top of page
installation guide

Additional Information
wall installation - the complete fitting, as supplied, is best suited for solid brick and concrete walls. use a 10 mm masonry drill bit for installation.
wood installation - for installation into solid wood, unscrew and remove the outer expansion sleeve from the fitting.
use a 6 mm wood drill bit to create a pilot hole, then screw the remaining fitting directly into the wood.
all .vreemd orbs are interchangeable, even after installation. simply unscrew an orb to replace it with another design, without removing the installed wall fitting.
the whole fittings can also be removed and relocated to a different position if needed.
bottom of page








